SX 2005

A surface protection varnish for Silkcoat Mineral Plaster, based on a pure acrylic binder

Structure: Pure Acrylic
Consumption: 6-10 m²/lt, 120-180 g/m²
Thinning Ratio: 40-50%

15 L, 5 L, and 2.5 L plastic buckets

技術データ

Structure

Pure Acrylic

Consumption

6-10 m²/lt, 120-180 g/m²

Thinning Ratio

40-50%

Application Tools

Roller or spray equipment

Drying Time

4-8 hours; hardening for topcoats 24 hours

Density

1.03 ± 0.02 g/ml

Produced specifically for mineral plaster, SX 2005 Varnish provides excellent water resistance thanks to the film layer it forms. Besides adding decorative vibrancy to mineral plaster and other exterior surfaces, it increases the exterior durability of mineral plaster for many years of use. It penetrates the plaster surface and adheres very strongly. Being water-based, it is harmless to human health and the environment

Applied in two coats on mineral plaster and exterior surfaces

The surface must be cleaned of all dust, dirt and oil to obtain a clean, dry and sound surface. If needed, repair defects and cracks with Silkcoat Putty. Dilute Silkcoat SX 2005 with 10-15% clean water and apply in a single coat by roller or brush. Clean tools with water. During application and throughout the 24-hour full curing period, ambient and surface temperatures should be between +5°C and +35°C. Flash point 41°C; flammable, harmful if inhaled or swallowed

安全上の注意

S2: Keep out of reach of children. S24/25: Avoid contact with eyes and skin. S46: If swallowed, seek medical advice immediately and show the container or label. Store the product in a tightly closed container. Do not dispose of into drains

Can be stored for a minimum of 2 years in a cool, clean, and dry environment, protected from direct sunlight, provided the container remains unopened